When base current is removed the transistor becomes fully off, this stage is called as the Cut-off Region.Īs mentioned in the features of the S8050 transistor is commonly used in push pull configuration with Class B amplifier. This stage is called Saturation Region and the typical voltage allowed across the Collector-Emitter (VCE) or Collector-Base (VCB) could be 20V and 30V respectively. When this transistor is fully biased then it can allow a maximum of 700mA to flow across the collector and emitter. To bias a transistor we have to supply current to base pin, this current (IB) should be limited to 5mA. The maximum amount of current that could flow through the Collector pin is 700mA, hence we cannot drive loads that consume more than 700mA using this transistor. However at a normal operating collector current the typical value of gain will be 110. Since it is very high it is normally used for amplification purposes. It has a maximum gain value of 400 this value determines the amplification capacity of the transistor normally S8050. S8050 is a NPN transistor hence the collector and emitter will be left open (Reverse biased) when the base pin is held at ground and will be closed (Forward biased) when a signal is provided to base pin. Note: Complete Technical Details can be found in the S8050 datasheet given at the end of this page. High Used in push-pull configuration doe Class B amplifiers. Continuous Collector current (IC) is 700mA.Low Voltage, High Current NPN Transistor.
0 Comments
Leave a Reply. |